When you issue a trepctl offline command, Tungsten Replicator will bring all channels to the same point in the log and then go offline. This is known as going offline cleanly. When a Replica has been taken offline cleanly the following are true:

When parallel replication is not enabled, you can take the replicator offline by stopping the replicator process. There is no need to issue a trepctl offline command first.

Putting a replicator offline may take a while if the slowest and fastest channels are far apart, i.e., if one channel gets far ahead of another. The separation between channels is controlled by the maxOfflineInterval parameter, which defaults to 5 seconds. This sets the allowable distance between commit timestamps processed on different channels. You can adjust this value at installation or later. The following example shows how to change it after installation. This can be done at any time and does not require the replicator to go offline cleanly.

Click the link below to switch examples between Staging and INI methods...

Show Staging

Show INI

shell> tpm query staging
tungsten@db1:/opt/continuent/software/tungsten-replicator-7.1.3-3

shell> echo The staging USER is `tpm query staging| cut -d: -f1 | cut -d@ -f1`
The staging USER is tungsten

shell> echo The staging HOST is `tpm query staging| cut -d: -f1 | cut -d@ -f2`
The staging HOST is db1

shell> echo The staging DIRECTORY is `tpm query staging| cut -d: -f2`
The staging DIRECTORY is /opt/continuent/software/tungsten-replicator-7.1.3-3

shell> ssh {STAGING_USER}@{STAGING_HOST}
shell> cd {STAGING_DIRECTORY}

shell> ./tools/tpm configure alpha \
    --property=replicator.store.parallel-queue.maxOfflineInterval=30

Run the tpm command to update the software with the Staging-based configuration:

shell> ./tools/tpm update

For information about making updates when using a Staging-method deployment, please see Section 9.3.7, “Configuration Changes from a Staging Directory”.

shell> vi /etc/tungsten/tungsten.ini

[alpha]
...
property=replicator.store.parallel-queue.maxOfflineInterval=30

Run the tpm command to update the software with the INI-based configuration:

shell> tpm query staging
tungsten@db1:/opt/continuent/software/tungsten-replicator-7.1.3-3

shell> echo The staging DIRECTORY is `tpm query staging| cut -d: -f2`
The staging DIRECTORY is /opt/continuent/software/tungsten-replicator-7.1.3-3

shell> cd {STAGING_DIRECTORY}

shell> ./tools/tpm update

For information about making updates when using an INI file, please see Section 9.4.4, “Configuration Changes with an INI file”.

The offline interval is only the the approximate time that Tungsten Replicator will take to go offline. Up to a point, larger values (say 60 or 120 seconds) allow the replicator to parallelize in spite of a few operations that are relatively slow. However, the down side is that going offline cleanly can become quite slow.

If you need to take a replicator offline quickly, you can either stop the replicator process or issue the following command:

shell> trepctl offline -immediate

Both of these result in an unclean shutdown. However, parallel replication is completely crash-safe provided you use transactional table types like InnoDB, so you will be able to restart without causing Replica consistency problems.