The data replicated from MySQL can be any data, although there are some known limitations and assumptions made on the way the information is transferred.
The following are required for replication to Amazon Aurora:
Table format should be updated to UTF8 by updating the MySQL
To prevent timezone configuration storing zone adjusted values and
exporting this information to the binary log and Amazon Aurora, fix
the timezone configuration to use UTC within the configuration file
Amazon Aurora Host
Create the Amazon Aurora Instance
If the instance does not already exist, create the Amazon Aurora MySQL-based instance and take a note of the IP address (Endpoint) reported. This information will be required when configuring the replicator service.
Also take a note of the user and password used for connecting to the instance. This can be set and configured when the instance is created.
Check your security group configuration.
Ensure that the port and IP configuration within the security group configuration are set correctly so that the host can be connected to the remote MySQL instance.
Change Aurora instance properties
Depending on the configuration and data to be replicated, the
parameter of the running instance may need to be modified. For
parameter may need to be increased.
In addition, the
hours setting may need to be extended to ensure that the
binary log information is available for reading by Tungsten Replication
For more information on changing parameters, see Section 6.10.4, “Changing Amazon Aurora Instance Configurations”.