10.3. tpm Staging Configuration
Before installing your hosts, you must provide the desired configuration.
This will be done with one or more calls to tpm configure
as seen in the Chapter 2, Deployment. These calls place the given
parameters into a staging configuration file that will be used during
installation. This is done for dataservices, composite dataservices and
Instead of a subcommand, tpm configure accepts a service
name or the word
defaults as a subcommand.
This identifies what you are configuring.
tpm configure [service_name|defaults] [tpm options] [service configuration options]
In addition to the Section 10.7, “tpm Configuration Options”, the
common options in Table 10.4, “tpm Common Options”
may be given.
The tpm command will store the staging configuration in
the staging directory that you run it from. This behavior is changed if you
$REPLICATOR_PROFILES defined in the environment. If present,
tpm will store the staging configuration in that
directory. Doing this will allow you to upgrade to a new version of the
software without having to run the tpm fetch command.
If you are running Tungsten Replicator, the tpm command
$REPLICATOR_PROFILES if it is available, before