6.9. Connector Command-Line Interface

The connector command is used for various operations that affect the Tungsten Connector, for example, starting and stopping the Tungsten Connector, getting status, updating and debugging.

When using the connector command-line tool, the following sub-commands are available:

Table 6.2. Connector Command Line Sub-Commands

OptionDescription
client-listReturn a list of the current client connections through this connector.
condrestartRestart only if already running
consoleLaunch in the current console (instead of a daemon)
dumpRequest a Java thread dump (if connector is running)
graceful-stop {seconds}Stops the connector gracefully, allowing outstanding open connections to finish and close before the connector process is stopped. {seconds} is an integer of zero or more, and is required. The connector will shut down immediately if there are no active connections. Specifying zero (0) wlll cause a shutdown without waiting for connections to terminate.
installInstall the service to automatically start when the system boots
reconfigureReconfigure the connector by forcing the connector to reread the configuration, including the configuration files and user.map.
removeRemove the service from starting during boot
restartStop connector if already running and then start
startStart in the background as a daemon process
statusQuery the current status
stopStop if running (whether as a daemon or in another console)

For more information, please see Section 8.7, “The connector Command”.